Publicité
Les langues disponibles
Les langues disponibles
Step 3.
To install the housing in the ceiling, position it between the joists and
extend the brackets to the adjacent joists.. Mark the screw locations (at
the top of the keyhole on each bracket) on the joists.
The bottom edge of the housing should be flush with the bot-
tom of the joist. (Figure 4)
Step 4.
Remove the housing and drive the screws part way into the joists at the
marked locations. (Figure 5)
Wiring diagram
For Fan-Light Combination
Maintenance
1.
Turn the power off and lock it out prior to servicing or cleaning.
2.
To clean the grille, first remove it from the fan then use a soft brush
and clean water to remove the dirt. If the dirt is not easily removed,
wash with a neutral detergent.
3.
In order to remove the impeller and housing for maintenance, first
remove the light, night light and reflector (if applicable). Then unplug
the electrical connection and remove the 4 screws that secure the
fan assembly to the housing. To clean the impeller and housing,
remove the motor and then wash with water or a neutral detergent,
as required.
Keep all electrical components away from water. Do not use
corrosive chemicals or water in excess of 60C (140°F) to
clean plastic parts.
Step 5.
Mount the housing using the screws in the joists and then secure them
Figure 5
tightly. Make all the electrical connections in the wire box, per the wiring
diagram, and attach the wire box cover. Attach the discharge duct tightly
onto the fan outlet.
Step 6.
To complete the installation, install the lamps (if applicable) and mount
the grille.
For Fan Only Units
In order for the fan to operate efficiently, keep the discharge
duct as straight as possible. (Figure 6)
Plug-in
7
Figure 6
Figure 7
fantech
Publicité
