T-Fal OPTIGRILL Mode D'emploi page 10

TF_OPTIGRILL-CERAMCOAT_210008945522/12/1415:45Page10
19
21
10
19 -20 When the color corresponding to
your choice of cooking level appears,
open the appliance and remove your
food.
21 Close the appliance. The control panel
will light up and set itself to 'choice of
program' mode.
Comment: the security system will turn
20
off automatically if no program selec-
tion is made.
Cooking more food
If you want to cook a second batch of
food, please pre-heat the appliance
again (see section 2. Pre-heating, start-
ing from point 9) even if you want to
cook the same type of food.
How to cook another batch of food:
After finishing your first batch of food:
1. Make sure the appliance is closed with
no food inside.
2. Select
mode/program (this step is necessary
even if you decide to pick the same
cooking mode than for the previous
batch of food).
3. Press the "OK" button: the appliance
starts pre-heating. The pre-heating is
symbolized by the cooking level indica-
tor that flashes purple.
4. The pre-heating is complete when an
audible beep is heard and the cooking
level indicator stops flashing purple.
5. After the pre-heating, the appliance is
ready for use. Open the grill and place
the food inside the appliance.
Important:
- Please note that any new batch of food,
the pre-heating phase is mandatory. Re-
member to always have the grill closed
and no food inside in order for the pre-
heating to effectively function.
- Then wait for the pre-heating to be com-
plete before opening the grill and place
the food inside.
N.B.: if the new pre-heating cycle is car-
ried out immediately after the end of the
preceding cycle, the pre-heating time will
be reduced.
the appropriate cooking