Utilitech 7131-01 Mode D'emploi page 9

EXISTING CONSTRUCTION – INSTALLATION FROM BELOW (NO ATTIC ACCESS)
4. Insert fan body (A) into ceiling cut out making sure to align
the duct connector with the fan body (A).
5. Secure the fan body (A) from below using 2 long wood
screws (AA) through the flange into the wood support
and 2 long wood screws (AA) through the flange into
the joist.
Hardware Used
AA
Long wood screw
6. Turn on the power source. Check fan for any abnormal
sound or vibration.
EXISTING CONSTRUCTION – INSTALLATION FROM ABOVE WITH SUSPENSION BRACKETS
(ATTIC ACCESSIBLE) ONLY IF UNABLE TO ATTACH DIRECTLY TO THE JOIST(S)
1. For joist spacing 16 in. - 24 in., insert suspension bracket I
(C) into the bracket cover on the duct connector side.
Then attach suspension bracket II (D) and suspension
bracket III (E) to the back of the fan body (A).
2. Secure the fan body (A) to joist with suspension brackets
(D, E) using long wood screws (AA).
Hardware Used
AA
Long wood screw
4
5
x 4
6
1
E
2
AA
x 6
9
AA
A
A
A
D
AA
E
Lowes.com
A
C
D