Publicité
Les langues disponibles
Les langues disponibles
Fuel gas smell
Liquid propane gas and natural gas have artificial odorants, which have been added specifically to enable the detection of fuel
gas leaks. In case of leaking gas, you will normally be able to smell the gas. Since propane (liquid gas) is heavier than air, you
will be able to smell the gas in low height near the ground.
TAKE IMMEDIATE ACTION EVERY TIME YOU SMELL GAS!!
Ÿ Do not conduct any acts that could ignite the gas. Do not operate any electric switches.
Ÿ Do not unplug any power or extension cables. Do not ignite any matches or other ignition sources. Do not use your phone.
Ÿ Ensure that all persons immediately leave the building and remove themselves from the danger zone.
Ÿ Propane gas (liquid gas) is heavier than air and can settle in low height. When suspecting a propane gas leak, stay away
from low sections.
Ÿ Use your neighbour's phone and call the fuel gas supplier and the fire brigade. No longer enter the building or the area.
Ÿ Stay outside the building and away from the danger zone until it/they have been declared safe by the fire brigade or the
gas supplier.
Ÿ Finally, have the fuel gas service technician and the fire brigade conduct a test of the leaked gas. Ensure that you ventilate
well the building or area prior to returning. Properly trained service technicians must repair all leaks, test for further leaks
and then turn device on again.
Activation
To Turn on the heater
1. Turn on the valve on the gas supply cylinder completely.
2. Press and turn the variable control knob to PILOT position (counter-clockwise 90°).
3. Press down the variable control knob and hold for 30 seconds. While holding down the variable control knob, press the
igniter button several times until the pilot flame lights. Release the variabel control knob aafter the pilot flame lights.
Note:
- If a new tank has just been connected, please allow at least one minute for the air in the gas pipline to purge out
through the pilot hole.
- When lighting the pilot flame make sure that the variable control knob is continuously pressed down while pressing
the igniter button. Variable control knob can be released after the pilot flame lights.
- Pilot flame can be watched and checked from the small round window with sliding lid located at the bottom of the
flame screen (to the left or right side of the controller).
- If the pilot flame does not light or it goes out, repeat step 3.
4. After the pilot flame lights, turn the variable control knob to maximum position and leave it there for 5 minutes or more
before turning the knob to desired temperature positon.
To turn OFF the heater
1. Turn the variable control knob to PILOT position.
2. Press and turn the variable control knob to OFF position.
3. Completely turn off the valve on the gas bottle.
Variable control knob
45
OFF
HI
LO
Ignitor
V1/2019-EM-Classic
Publicité
