empasa Classic light CZGB-A Mode D'emploi page 42

Assembly
5
Insert burner with gas steel pipe into standpipe.
Fasten burner with 4 x screws FF.
Fasten 3x spacers EE with 3x washers DD on
radiation shade B.
6
Slide two reflector plates into each other. Insert a screw GG and loosely screw on the cap nut HH.
Repeat the process to complete the installation of all three reflectors. Tighten all screws to the rolled
edge. Screw the reflector on the outer edge with screws GG and cap nuts HH.
42
V1/2019-EM-Classic