Napa 6-1012 Instructions page 3

AIR SUPPLY
Whip Hose
Do Not In stall
Quick Coupling Nipple
Here
Leader
Hose
Tools of this class operate on
a wide range of air pres s ures.
We recommend that air pressure
mea s ures 90 PSI at the air inlet
while in use. Low pressure (less
than 90 psig 6.2 bar) re d uc e s the
speed and performance of all air
tools. High pres s ure (over 115 psig
8.0 bar) exceeds the rated capacity
of the tool, which will short e n tool
life through faster wear and could
cause injury.
Always use clean, dry air. Dust,
corrosive fumes, and/or water in
LUBRICATION
Lubricate the air motor daily with
NAPA air tool oil. If no air line oiler
is used, run 1/2 oz. of oil through
the tool. The oil can be squirted
OPERATION
Always place a chisel in the
hammer and hold the tool down
to the work before operating.
Damage to the tool or the
retainer may result if this
precaution is not followed.
The chisel retainers are not
designed for complete safety
against accidental release of
cutters or hammers. To avoid
injury, the throttle must never
please revieW all Warning insTrucTions prior To operaTion. save This Man u al for fuTure ref er ence.
6-1012
Nipple
Quick Coupler Oiler
the air line will cause damage to
the tool. Drain the air tank daily.
Clean the air inlet filter screen at
least per week.
The air inlet used for con n ect i ng
air supply, has stan d ard 1/4" NPT
American Thread. Line pressure
should be increased to compensate
for unusually long air hoses (over
25 feet). Minimum hose diameter
should be 3/8" I.D. Fittings should
have the same inside dimensions
and should be tightly secured.
into the tool air inlet or into the
hose at the nearest con n ec t ion to
the air supply, then run the tool.
The oil plug is only for adding
be depressed unless the chisel is
held firmly against the work place.
When tool is not in actual use, the
chisel must be removed. During
operation, safety goggles should
always be used to guard against
flying rust and chips. When using
tool, regulate the speed so that
the chisel is not being driven out
of the cylinder. If piston is allowed
to strike the cylinder wall, internal
damage will result.
Air Supply
Filter
Regulator
Drain Daily
3
S
pecificationS
Blows per Minute ............. 2,200 BPM
Bore Diameter .............................3/4"
Piston Stroke ........................... 3-3/4"
Air Inlet ............................... 1/4" NPT
Min. Hose Size ..................... 3/8" I.D.
Avg. Air Cons. ......................... 4 CFM
Recom. Air
Pressure ..................90 PSIG (6.2 BAR)
Weight .................................. 5.66 lbs.
Length ......................................10.63"
Sound Power Level ...............110 dBA
Air Regulator
Air Inlet
multi-purpose grease after repair
or maintenance of the impact
mechanism. Overfilling will cause a
re d uc t ion in the power of the tool.
To change chisel, pull back on the
retainer and insert chisel. Release
retainer.
To regulate air, turn air regulator
knob out for maximum air pressure
and in for minimum.
Rev. 10/16/13