Ricatech RR700 Mode D'emploi page 2

WARNING:
WARNING:
CAUTION:
On Placement
Do not use the unit in places which are extremely hot, cold, dusty, or humid.
Place the unit on a flat and even surface.
Do not restrict the airflow of the unit by placing it in a place with poor airflow, by covering it with a cloth.
FCC Information
This device complies with Part 15 of FCC Rules. (USA VERSION ONLY)
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesirable
operation.
On Safety
When connecting or disconnecting the AC cord, grip the plug and not the cord itself. Pulling the cord may damage
it and create a hazard.
When you are not going to use the unit for a long period of time, disconnect the AC power cord.
On Condensation
When left in a heated room where it is warm and damp, water droplets or condensation may form inside the
unit. When there is condensation inside the unit, the unit may not function normally. Let the unit stand for 1 to 2
hours before turning the power on, or gradually heat the room up and dry the unit before use.
WARNING:
Should any trouble occur, disconnect the AC power cord and refer servicing to a qualified
technician.
Do not place anything directly on the top of the unit. Damage to the unit can result.
THIS UNIT EMPLOYS A LASER.
ONLY QUALIFIED SERVICE PERSONNEL SHOULD OPEN THE COVER IN ATTEMPT TO
SERVICE THIS DEVICE DUE TO POSSIBLE EYE INJURY.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT. (USA AND CANADA ONLY)
USE OF ANY CONTROLS, ADJUSTMENTS, OR
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
LASER SAFETY
ENGLISH - 1
The Lighting flash with an arrowhead symbol,
within the equilateral triangle, is intended to alert
the user to the presence of uninsulated
"dangerous voltage" within the product‟s enclosure
that may be of sufficient magnitude to cause an
electric shock.
The exclamation point within the equilateral
triangle is intended to alert the user to the
presence of important operating and maintenance
(servicing) instructions
in this owner manual.