KLASS Fan MELTON LT Manuel D'utilisation page 15

· For household and indoor use only.
· Do not install in areas / places near chemicals and flammable products,
such as gas stoves, wet and humid places, such as bathroom, or high
vibration or impact and continuous direct exposure to the wind.
· This manual is not intended to instruct or assist untrained or
unqualified persons to install the ceiling fan.
· Fan, light kit and mounting plate must be earthed.
· According to safety regulations, the lowest point of the fan blade
must be at least 2.3 metres from the floor.
· Do not allow the blades to come into contact with any object.
· Please check carefully and make sure that ceiling joists are strong
enough and of adequate size to support the weight of about 40 kg.
· To reduce the risk of fire, electrical shock or personal injury, please
make sure that the fan mounting bracket is directly supported from
the building structure. Do not mount to an outlet box.
· The device must be permanently connected to the power supply via
a double pole switch with a contact separation of at least 3 mm in all
poles.
· Do not connect the ceiling fan to a dimmer or regulator.
· The mounting plate must be firmly screwed to a load bearing
structure eg. a concrete must be securely nailed or screwed between
the beams.
· Attach fan blades after the fan motor housing is installed and properly
secured. Keep the fan motor and fan blades in original package until
is ready to be installed.
· Check and confirm, after the fan is completely installed, that all
connections are proper and secure to prevent the fan from falling or
causing property damages or personal injury.
· Take care not to bend or damage the motor drive shaft or fan blades
when handling or installing them. If such defect is noticed, please
contact the customer service before installation of the ceiling fan.
· Use of unapproved remote control voids the warranty. Only use our
remote control.
· Do not remove the fan from the ceiling after installation.
· Do not insert any objects between the blades and the motor housing.
· Never use accessories not recommended or supplied by the
manufacturer.
13