Intex ZX300 Deluxe Manuel D'utilisation page 10

(178IO) ZX300 DELUXE AUTOMATIC POOL CLEANER ENGLISH SIZE: 4.875" X 7.25" PANTONE 295U 08/21/2020
SETUP INSTRUCTIONS (continued)
8. hold the cleaner with the top facing up. slowly lower the device
into the water to evacuate the air inside the cleaner and the cleaner
will gradually sink to the bottom of the pool floor. see fig. 8.
9.
Turn on the filter pump and make sure water is flowing through
the micro-screen (6) and the pressure release valve (7). The
auto cleaner is now moving and vacuuming the pool floor and
pool wall. see fig. 9.
Note: The cartridge filter pump or sand filter pump will clean the
pool water. it's essential to clean or replace the filter cartridge or
backwash sand media frequently to keep the water clean.
if the Auto cleaner is paired up with a sand filter pump, the
system flow will diminish and the pressure will rise as indicated
by the sand filter pump pressure gauge reading (from green to
yellow zone), this is normal. Disconnect the Auto cleaner from
the pool and check if the sand filter pressure gauge reading
will drop back to the green zone. Refer to the sand filter pump
manual for more details.
S AVE THESE INSTRUCTIONS
7
6
Page 10
178A
8
9