How To Operate The Cd (Mp3) Player; About Compact Discs; About Brand New Cds - Fujitsu Ten Eclipse CD2000 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation

How to operate the CD (MP3) player

About compact discs

• The information recorded on a compact disc is read by a laser beam, so nothing touches the disc
surface. A scratch on the recorded surface or a badly warped disc may cause deteriorated sound
quality or intermittent playback. Observe the following precautions to ensure high quality sound
performance:

About brand new CDs

Rough Edges
Ballpoint pen
Rough Edges
Flakes
Recorded surface
12
• Do not leave an ejected disc in the disc slot for very long; the disc may
warp. Discs should be stored in their cases and kept away from high
temperature and humidity.
• Do not stick a piece of paper or tape on the disc. Do not write on or
scratch either side of a disc.
• Discs spin at a high speed inside the deck. Keep cracked or warped
discs out of the player to avoid damage to the equipment.
• Avoid touching the recorded surface when handling a disc; handle
discs by their edges.
• You may notice that some brand new discs are rough around the
center hole or outside edge. Remove the rough edges with the side of
a ballpoint pen, etc. Rough edges may prevent proper loading in the
deck. Flakes from the rough edges may also stick to the recorded
surface and interfere with playback.

Publicité

Table des Matières
loading

Table des Matières