Installation And Mounting - Ecco 10 Serie Instructions D'installation Et D'utilisation

Installation & Mounting:
Mounting
Before proceeding with installation, plan all wiring and cable routing. Select the mounting location for the lightbar on a flat, smooth surface
and center the unit across the width of the vehicle. The mounting location for the light bar should be chosen such that the light bar is level
and visibility to approaching traffic is optimized. Mounting should be such that there is no less than 12mm ( ½" ) clearance between the roof
and the lightbar at any point.
!
Caution:
When drilling into any vehicle surface, make sure that the area is free from any electrical wires, fuel lines, vehicle upholstery, vehicle
support members, etc. that could be damaged.
Permanent Mounting 15 & 30 Series
1. Determine the location of the lightbar, and the best route for the wiring.
2. Determine the position of the four mounting feet and drill the 8.5mm - 9.0mm diameter (11/32") mounting holes accordingly.
The spacing of the mounting hardware from front to back is fixed at 120mm. The spacing of the mounting hardware from left to right is
adjustable. It is suggested that the positioning of the feet be symmetrical and near the curved edges of the roof where the roof is
strongest.
3. Insert the heads of the M8 mounting bolts into the opening at the end of the slots on the base of the lightbar. Push the rubber mounting
feet over the bolts to hold them in position. Slide the bolts along the extrusion so they are symmetrical about the bar and line up with the
holes in the roof.
4. Mount the lightbar, with the bolts going through the holes drilled in step 2, routing the wire as planned in step 1 (refer to diagram). See
the Wiring section of this manual for further wiring instructions. Install washers and nuts and secure the unit. The use of thread locking
compound is recommended.
920-0052-00 Rev. F Page 3 of 17