Numan Mini Two Mode D'emploi page 71

Depending on your device, you may need to make multiple attempts at Pairing and/or Connecting to the NUMAN
Mini Two, but please give your device adequate time to Pair or Connect before repeating the process.
Pairing A BT Wireless Technology Enabled iPhone /iPod touch/iPad:
1. Press source to select BT mode. This will power on the BT. Turn the volume up about ¼ to start. Also turn up
the volume on the source device (the device you are streaming from).
2. Select "Settings". (Depending on software version).
3. Select "General".
4. Select "BT".
5. Switch BT "On" to initiate searching.
6. Select "NUMAN Mini Two" when it appears on the display.
7. You will hear a ring tone from the NUMAN Mini Two and you can begin playing your music files wirelessly.
Adjust the volume level on your device. You should not have to pair your iPhone/iPod/iPad again. The volume
output level of music files varies.
If you prefer an even higher output level, check the settings in your iPhone/iPod touch/iPad: Set the EQ Off, the
SoundCheck Off, and the Volume limit Off. If you encounter a problem Pairing, press the small arrow to the right
of "NUMAN Mini Two BT" on your iPhone /iPod touch/iPad display and select "Forget this Device", then repeat
the Pairing process.
Depending on your device you may need to make multiple attempts at Pairing and / or Connecting to the
NUMAN Mini Two, but please give your device adequate time to Pair or Connect before repeating the process.
71