Digi Sport Instruments Multisport DT742 Mode D'emploi page 4

www.digisportinstruments.com
INSTRUCTION MANUAL
SCOREBOARD
DT721 « Multi-Sport »
TIME SETTING
1. Switch the scoreboard "ON".
2. Select the time count mode.
The scoreboard has the countdown
to 00:00 and on the display,  - : - -
appears
For the count up, press the " + "
until the selected time. On the
display,  - : - - appears
Button " – " is for setting the
countdown mode and button « + »
for setting the count up mode.
3. Push the' PROG/START-STOP "
button to enter in the setting mode
4. Use (+, -)to adjust the minutes.
5. Press the « PROG » button.
6. Adjust (+, -) for the seconds.
7. Press the « PROG » button
again to end the setting.
The timer is set. By pressing the
Red button, you can start or stop
the timer.
lf the timer is on, the green lights is
shining. The timer has the
automatic and manual alarm. To
set another timer, the current timer
has to be stop.
To reset the timer, press the " + - "
buttons together, while the timer is
stopped.
SCORE 199 AND 9
By pressing the « SCORE »
buttons, you can set the score from
0 to 9 or 0 to 199.
To reset the score, press the
buttons " HOME and GUEST "
together.
Press the "SCORE" button, and
the score will go down. If the score
does not blink, the score goes up.
PERIOD
Press the « PERIOD » button, to
select the periods from 1 to 9.
TIME OUT
Press the "TIME OUT" button, T,
TT, TTT, will appear on
displayPress "TIME OUT "button.
The countdown goes from 60s to 0.
When the time is out, the alarm
rings.
The alarm ring also 15s before the
end of TIME OUT
After the end of « TIME OUT », the
timer is ready.
Press « TIMEOUT » again to
cancel the time out.
On the scoreboard, it is possible to
indicate 3 times out for each team.
PENALTY
The penalty control indicates 2 and
4 min (penalty time) for each team.
You can only add penalty time
when the main timer is stopped.
The « RESET » button allow to
cancel the penalty.
1. Select the penalty.
2. Adjust with « ENTER PLAYER
ADJUST » button the first digit of
player number.
3. Push the selected penalty button.
4. Adjust with « ENTERPLAYER
ADJUST » button the second digit
of player number.
5. Push the selected penalty button.
BREAK
After the period time, it is possible
to count the break. Press the
« PAUSE » button.
The break can be from 00:00 to
99:59. Press "PAUSE" to stop the
time.
24S
Plug the remote form the KIT24 to
the main remote.
ON/OFF : press "24S" during 5
seconds to stop the main time,
START : Press the 2nd button on
the remote. An alarm will ring when
the countdown is on 0.