Connecting Poe - Avigilon 1.0-H3M-DO1 Guide D'installation

Connecting PoE

The HD Micro Dome camera can only be powered by Power over
Ethernet (PoE).
1. Pull the required Ethernet cable to the camera.
2. If you are installing the camera outdoors, slide the cable
through the supplied rubber boot.
3. Crimp the end of the cable with an Ethernet connector.
4. Connect the crimped cable to the Ethernet Port.
5. Check that the camera's status LEDs indicate the correct
state. See LED Indicators on page 10 for more
information.
6. If you installed the rubber boot, slide the boot over the end
of the cable assembly.
7. Tuck the cable assembly away.
a. If you are storing the cable inside the wall, push the
cable assembly through the larger hole in the
mounting surface.
5