Venmar vanEE 41304 Guide D'installation Et D'utilisation

The illustrations in this document are generic; your control appearance may be slightly different from the ones shown.
Electrical wiring must be done by qualified personnel in accordance with all applicable codes and standards.
Before connecting wires, unplug the unit or switch power off at service panel and lock service disconnecting
means to prevent power from being switched on accidentally. Always wear safety glasses and gloves while
performing these instructions.
INSTALLATION

Unplug the ventilation unit.
NOTE: If the control is to be installed in an electric box, go to step

7
Cut a 2 / " x 1¾" hole in a wall, at a
8
convenient location for the control.
Route a cable (type 22/4) for the
control from the unit to this hole. See
figure at right.

Temporarily place the control over the
hole and mark both mounting screw hole
positions.

Remove the control, drill both screw
holes (3/16" Ø) in wall and insert the wall
anchors (included).

Strip the end of the cable to access the 4 wires (about 3"). Strip the
end of each wire (about 1/4"). Connect the wires to the terminals,
regardless of the wire color. Note which wire color has been
chosen for each terminal. See illustration below.
VC0236

Mount the control to the wall.
I U
NSTALLATION AND
EE
VÄN PART NO
READ AND SAVE THESE INSTRUCTIONS
Ø 3/16", typ.
VC0213A
12V
D-
D+
Gnd
VC0214
G A
SER UIDE FOR UTOMATIC
. 41304 V
ENMAR PART NO
!
WARNING

Perform
connector of the unit, as shown below. For more details, refer to
the installation manual of the ventilation unit.
NOTE: To avoid miswiring, refer to the notes taken at step
to match the wire color with the right terminal.

.
VC0235

Plug the ventilation unit and test the wall control.
VC0184
RECIRC: Recirculate air inside the house at MAX speed. Not
available on all units.
INT: Within a one hour period, the system will operate in MIN speed
for 20 minutes.
MIN/MED/MAX: Continuous exchange ventilation at selected
• Press the TURBO button to get 4 hours of ventilation in MAX
speed. The TURBO indicator will light up. Once the 4-hour
period is done, the system will operate according to the previous
setting.
• Press the AUTO button to let the system operate according to
outdoor temperature. The AUTO indicator will light up.
• If the maintenance indicator is lit, it means that the filter needs
to be cleaned or replaced. Once the filter is cleaned or replaced,
press the AUTO button for five seconds to reset the maintenance
indicator. If the maintenance indicator flashes, the LCD screen
on the unit will give the error code. Refer to the Troubleshooting
section in the ventilation unit user guide for more information.
C
ONTROL
. 41404
the electrical connection
HOW TO USE THE CONTROL
The main button works following this
sequence:
• Click 1 = RECIRC (if available)
• Click 2 = INT
• Click 3 = MIN
• Click 4 = MED
• Click 5 = MAX
• Click 6 = OFF
• and so on
The indicator lights up as per the selected
mode.
speed.
to the terminal

12V
D-
D+
Gnd
23842 rev. 01