Diamond D604-EKS Mode D'emploi page 8

Pag. 8
Tank (5)
Tank (5)
Tank (5)
Tank (5)
Tank (5)
Tank (5)
Tank (5)
Tank (5)
Tank (5)
Tank (5)
Tank (5)
Boiler (6)
THERMO-STOP TIME OUT: for further information, see the
"Adjustment and checks". If the signal reappears, contact a
qualified technician.
TANK FILL UP TIME OUT: the tank did not fill up. Try switching
Boiler (6)
the appliance off and on, and run a new fill-up cycle. Ensure the
overflow is fitted correctly if necessary. If the signal reappears,
contact a qualified technician.
Boiler (6)
TANK PROBE FAULTY (OPEN). Contact a qualified technician..
Boiler (6)
TANK PROBE FAULTY (SHORT-CIRCUITED). Contact a
qualified technician..
Boiler (6)
BOILER
technician.
Boiler (6)
BOILER PROBE FAULTY (SHORT-CIRCUITED). Contact a
qualified technician.
BOILER FILL UP TIME OUT: boiler does not fill up. It is not
Boiler (6)
possible to run a rinsing cycle. Ensure the water tap upstream the
appliance is open. Run a new complete cycle. If the signal
reappears, contact a qualified technician.
Boiler (6)
TANK TEMPERATURE TOO HIGH: Contact a qualified
technician.
Boiler (6)
BOILER TEMPERATURE TOO HIGH: Contact a qualified
technician..
Boiler (6)
ELECTROMECHANICAL SAFETY: the boiler or tank thermostats,
or the tank safety pressure sensor have engaged. Contact a
qualified technician.
TANK LEVEL INCORRECT: the tank pressure sensor has
Boiler (6)
measured an incorrect tank level. Contact a qualified technician.
(*) upon request, such messages may be deactivated by a
qualified technician.
If the signal reappears, contact a qualified technician.
PROBE FAULTY (OPEN). Contact a
GB
qualified