Jays x-Five Wireless Mode D'emploi page 5

EN English
Power on/off and pairing
To power on, press and hold the on/off button for 2s, the LED will blink in blue
three times. To pair, press and hold the on/off button for 5s, the LED will blink
x-Five Wireless". The blinking LED will turn off upon a successful connection
followed by a short audio beep.
To power off, press and hold the on/off button for 2s, the LED will blink in red.
Reconnecting
Next time you power on, the headphones will automatically try to reconnect
to the most recently used device. If not found, or if you manually disconnect
through your device, pairing mode will automatically be initiated again. To
force pairing mode, press and hold the on/off button for 5s from off state.
Using the audio cable
Connect the audio cable to the audio jack and your device. The LED will blink
® pairing with your device disconnects automatically.
Battery status and charging
When paired with iOS devices, the battery status of the headphones is shown
in the upper right corner on the iOS device.
hours (depending on temperature and charger).
Charging is indicated by a solid red light on the charging LED, and a full
charge is indicated by a solid green light on the charging LED.
Troubleshooting
Problem pairing and connecting
• Make sure the headphones are not connected to another device.
•
• Move the headphones closer to the device or alter their positions
• Verify no other wireless equipment interfere with your earphone
Problem with sound transmission
materials and other wireless equipment can interfere with the wireless signal
between your device and earphone.
®
Legal & Warranty
Environmental information
This product complies with international directives, including but
not limited to WEEE Directive (2012/19/EU). Do not dispose with
normal household waste. Please consult your local waste disposal
authority for guidance on how to properly recycle or dispose of
this product.
Manufacturer's limited warranty
is free from faults in the materials, design and workmanship when it was sold
to the purchaser. If you are not able to submit the receipt when making a
warranty claim you may be obliged to pay for any repairs carried out. Proof
of purchase must clearly state the date of purchase, name of the product and
authorized resellers' details
The Warranty Period cannot be extended or renewed due to subsequent
resale or replacement of the product. This Limited Warranty does not affect
your legal rights under your applicable national laws relating to the sale of
consumer electronic products. Defective parts replaced within the Limited
What is not covered by the limited warranty?
• Faults caused by wear and tear, age-related battery capacity loss, accidents,
dropping, mechanical damage, moisture, chemical products, abnormal
impact damage or force majeure.
•
How to get warranty service
If you wish to make a Warranty Claim within the Limited Warranty Period,
to provide the proof of purchase and the affected part. Any defective parts
covered by the Limited Warranty will be repaired or replaced free of charge.
Replaced or repaired parts provided during the Warranty Period will be
warranted for the remainder of the original Warranty Period or for sixty (60)
days from the date of repair or replacement, whichever is longer. For FAQ
please visit www.jaysheadphones.com.