Installing The Omegascope™ Software And Manual - Omega SCOPE OMSP-2000 Serie Mode D'emploi

1.5 Installing the OMEGASCOPE™ software and manual
1) Do not connect the oscilloscope to the PC yet!
2) Insert the software CD into your CD-ROM
drive. It should start automatically. (If it does
not, follow the steps on the right.)
3) Click the "Install Software" button.
4) Follow the instructions on the screen to install
OMEGASCOPE™.
5) If an AC adapter is supplied with the
oscilloscope, fit the appropriate plug or cable
to the adaptor and plug the adaptor into the
AC supply. Plug DC the lead from the adapter
into the back of the oscilloscope. Switch on the AC power.
6) Connect the PC Oscilloscope to the PC (see connection drawing below).
Ignore any warnings that appear such as "This device can perform faster"
or "USB2 device connected to USB1 hub".
7) The "New Hardware Found Wizard" will run. Follow the instructions, and if
the wizard asks to connect to Windows Update, select "No". If a warning
about Windows Logo testing appears, click "Continue Anyway".
8) With some products, the "New Hardware Found Wizard" will run twice. If
this happens, repeat the previous step.
9) Click the Windows Start button, go to "Programs" and then
"OMEGASCOPE™" to begin using the PC Oscilloscope.
10) If an oscilloscope probe is connected to the oscilloscope, you should see a
small 50 Hz or 60 Hz signal in the oscilloscope window when you touch
the probe tip with your finger.
M5063
Key:
1) PC Oscilloscope
2) PC Oscilloscope's USB port
3) USB cable
4) PC
5) PC's USB port
USB Oscilloscope Quick Start Guide
To start the CD manually:
1) Click the Windows
Start button and select
"Run..."
2) Type d:\omegascope
(where 'd:' is your CD-
ROM drive)
3) Press the Enter key
3