hager RTN300X Manuel page 17

RTN300X · RTN301X
Quick start configuration
Quick start configuration with IP intercom server RTD110X
The quick start area is specifically adapted to the subnet configuration of the IP intercom server.
The components in the subnet should not be changed except for the changes described here.
www.hager.com
!
Subject to technical changes
After calling up the Web inter-
face, select the "Quick start"
area and log in with the factory
Password:
into the IP door speaker
module.
NOTE:
There are also other basic
settings in the "Quick start"
area (e.g. volume and micro-
phone sensitivity).
In the "Expert" area in this in-
stallation variant, no settings
need to be made.
Configure the door speaker
module (with multiple inputs)
at the correct entrance and the
!
number of call buttons used.
Confirm your
"Save".
IP address, SIP registration
data and call button inputs for
the door speaker module are
now adapted to the configura-
tion defined in the IP intercom
server.
IMPORTANT:
In general, no further settings
will be necessary. For more in-
formation, please see the cur-
rent Easy Installation Guide
and, for special settings, the IP
system manual.
1234
settings with
17