Publicité
Les langues disponibles
Les langues disponibles
WARNING INFORMATION
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using these stands. It is also the responsibility of the stand
owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not legible, contact
NAPA for replacements. If the operator is not fluent in English, the product and safety instructions shall be read to and discussed with the operator
in the operator's native language by the purchaser/owner or his designee, making sure that the operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of portable automotive lifting and support devices is subject to certain hazards that cannot be prevented by mechanical means,
but only by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use
and operation of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its proper
use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly secured loads, overloading,
off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study, understand & follow all instructions before using.
• User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
• This stand is intended to assist in stablizing a vehicle that is supported by an automotive lift.
• Inspect the stand before each use. Do not use if damaged, altered, modified, in poor condition or has loose or missing hardware
or components. Take corrective action before using the stand.
• Center load on saddle. Do not use ends of saddle to support or stabilize load.
• Adequately support the vehicle before starting repairs.
• Be sure vehicle, vehicle components and stand are stable before performing any work.
• Do not exceed rated capacity. Do not shock load.
• Use only on a hard level surface capable of supporting the load.
• Use stands in pairs to stabilize the vehicle before starting repairs.
• Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the manufacturer's
authorized representative.
• Failure to heed these warnings may result in personal injury, property damage, or both.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
ASSEMBLY INSTRUCTIONS
1.
Attach legs (#20) to top plate (#13) with hardware (#14, #9 and #15) as shown on the exploded view drawing on page 4. Do not tighten
hardware.
2.
Attach small braces (#17) to mid plate (#16) with hardware (#2, #9 and #15) as shown on the exploded view drawing on page 4. Do
not tighten hardware.
791-2006A
OPERATING MANUAL FOR 791-2006A
WARNING
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
Rev. 04/20/20
Publicité
