Publicité
Les langues disponibles
Les langues disponibles
Step 4: Connecting the sliding drawer back
support to the locking top assembly.
Insert a 14mm bolt down through back left hole
in the locking top assembly, through the left hole
in the drawer support back panel, and finally through
the hole in the left drawer support side panel. Hand
tighten the bolt. Repeat for the back right side.
The locking top assembly, drawer supports
and drawer spacer should now all be
successfully connected.
Step 5: Connecting the bottom tray to the
chrome legs.
Pick up entire cart and place on top of the bottom
tray. Line up holes in bottom tray with holes in
chrome legs. Choose an aligned hole, position a
washer, and insert 10mm bolt through the washer
and hole. Attach inside with another washer and
nut. Hand tighten. Repeat with all remaining
aligned holes.
Step 6: Tighten all bolts.
At this point all bolts should be tightened. Tighten
bolts opposite each other rather than tightening all
bolts on one side first.
Step 7: Attaching handle to locking
drawer assembly.
Insert the 4 drawer handle screws through
the holes in the back of the drawer and tighten
with screwdriver.
8013A/8013ABK/8013ABL: Parts Breakdown & Operating Manual
4.
Side Panel Left
Bottom Tray
5.
7.
3
14mm
Bolt
Side Panel Back
Chrome Legs
Locking
Top Assy.
10mm Bolts
rev. 06/11/18
Publicité
