Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Step 1: Assembly preparation.
Clear table top and set locking top assembly on table
right side up. Position the locking top assembly so
the right side hangs off the table enough to expose
the square holes so the chrome legs can go through.
Insert one set of chrome legs through the 4 holes as
shown in figure 1.
Step 2: Connecting the locking top assembly
to the chrome legs.
On right side of cart, line up holes in top tray with
holes in the top of the chrome legs. Position a
washer, and insert a 10mm bolt through the washer
and holes. Attach inside with another washer and
nut. Repeat step 2 with remaining holes on right side
of cart.
Repeat steps 1 and 2 for left side of cart.
Step 3: Connecting the sliding drawer side
supports to the locking top assembly.
Before executing this step refer to figure 3.2 to make
sure you are putting the correct drawer support side
panel on the correct side.
NOTE: The locking drawer assembly will not
stay in place if the drawer support side panels
are put on incorrectly.
Insert a 14mm bolt through the left front side of the
drawer support side panel first and then up through
drawer spacer into hole in the locking top assembly.
Hand tighten the bolt. Repeat on right front side.
Once the drawer support side panels are attached
to the front of the locking top assembly, continue
to Step 4.
8013A/8013ABK/8013ABL: Parts Breakdown & Operating Manual
1.
Locking
Top Assy.
Chrome
Legs
Table
2.
Table
3.
Drawer
Spacer
14mm
Bolt
Side Panel Left
2
Chrome
Legs
Sliding Drawer
Side Panels
Locking
Top Assy.
Locking
Top Assy.
Be sure these
holes are at the
back of the cart
3.2
rev. 06/11/18
Publicité
