Axis Q1775-E Mode D'emploi page 15

• Composite video out (CVBS) - for easy installation using a video monitor. CVBS is
available for 2 minutes after pressing the button and should only be used during
installation.
Control Button
For location of the control button, see Hardware Overview on page 10.
The control button is used for:
• Resetting the product to factory default settings. See page 20.
• Ensuring the camera is level. Press the button for not more than two seconds to start the
levelling assistant and press again to stop. The status LED and buzzer signal (see page 13)
assist levelling of the camera. The camera is level when the buzzer beeps continuously.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see the User Manual.
SD Card Slot
NO NO TICE NO TICE TICE
• Risk of damage to SD card. Do not use sharp tools or excessive force when inserting
or removing the SD card.
• Risk of data loss. To prevent data corruption, the SD card should be unmounted before
removal. To unmount, go to Setup > System Options > Storage > SD Card and click
Unmount.
This product supports SD/SDHC/SDXC cards (not included).
For SD card recommendations, see www.axis.com
Specifications
Operating Conditions
Temperature
-40 °C to 50 °C
(-40 °F to 122 °F)
AXIS Q1775-E Network Camera
Humidity
10-100% RH (non-condensing)
15