Zen & Pur OSMOSEUR ORIGINE Manuel D'utilisation page 42

PROBLEM
The device does
not filter.
Abnormal noise
when filtering.
Waterleak.
44
PROBABLE CAUSES
The lid of the water intake tank is
not properly closed.
•
The water level of the reservoir
admission is below the minimum
level, the replace water symbol
flashes.
•
The water intake tank is not
not in place.
The water level of the intake tank
is below the minimum level.
•
The presence of air in the water
system.
•
Inadequate water quality,
non-functional reverse osmosis or
coal filter.
The receptacle is full.
•
The presence of a foreign object
in the one-way valve of the tank
support base.
•
Presence of a foreign object in the
seal of the tank.
•
Internal water leak.
SOLUTIONS
Properly put the lid of the
water intake tank back in place.
•
Fill the tank.
•
Put the water intake tank back
in place.
Fill the tank.
•
Open, then repeatedly close
the lid of the water intake tank,
so that air escapes from the
water circuit.
•
Replace the coal filter or
the reverse osmosis filter.
Empty the receptacle.
•
Clean the one-way valve.
•
Clean the seal.
•
Turn off and purge the device.
Contact customer service.