Zen & Pur OSMOSEUR ORIGINE Manuel D'utilisation page 36

2
Replacing and priming the coal filter, reverse osmosis filter and post-filter.
When the maintenance symbol lights up in red, the charcoal filter, the reverse osmosis
filter and the post-filter must be replaced. Turn off the appliance and replace the filters according
to the following procedure:
1.
Open the lid of the water intake tank and wait 5 seconds..
2.
Remove the water intake tank by holding it vertically and then emptying it.
Unplug the socket or switch.
3.
Keep the lower part of the coal filter (I) and rotate it counterclockwise. Remove the filter.
4.
Keep the lower part of the reverse osmosis filter (II) and rotate it counterclockwise.
Remove the filter.
5.
Gently remove the post-filter (III) with your fingers and set up the new
one by pushing it to the click.
6.
Insert the lower part of the coal filter (I) into its location and rotate the filter
clockwise until it clicks into place
7.
Insert the lower part of the reverse osmosis filter (II) into the location of the filter and rotate
the filter clockwise until it clicks into place.
8.
Put the water intake tank back in place at the back of the unit and close the lid.
9.
Hold down the operating control button (the same button you use to release water)
and plug in the device at the same time (while keeping the button pressed). The device beeps indicating that
filter replacement is taken into account.
38