Use The Brake; Empty The Bucket; Reset The Bucket; Maintenance - GreenWorks Pro ZTB432 Manuel D'opérateur

EN
Do not let go of the handle until the machine does not
move.
Put the machine on a level surface and apply the brake.
4.5

USE THE BRAKE

4.5.1 LOCK THE BRAKE
1. Step on the brake.
2. Repeat on the opposite side.
4.5.2 UNLOCK THE BRAKE
1. Step on the brake again.
2. Repeat on the opposite side.
4.6

EMPTY THE BUCKET

1. Stop the machine.
2. Squeeze the bucket release lever (20) to release the
bucket (1).
3. Hold the bucket handle (6) to lift the bucket (1).
4. Empty the bucket (1).
4.7

RESET THE BUCKET

1. Squeeze the bucket release lever (21) while pushing down
on the bucket handle.
2. Push it down until it clicks into place.
5

MAINTENANCE

Before maintenance, make sure that you
• stop the machine.
• wait until all the moving parts stop.
• remove the battery pack from the machine.
WARNING
WARNING
WARNING
English
Do not use strong solvents or detergents on the plastic
housing or components.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
5.1

CHANGE THE OIL

Change the oil each six months in the first year. Change the
oil each year in the remaining years.
5.1.1 EMPTY THE OIL
1. Remove the drain plug (9) with a wrench (12 mm) (not
included).
2. Drain the oil.
3. Install and tighten the drain plug (9).
5.1.2 ADD THE OIL
1. Remove the oil plug (10) with a 10.5 mm wrench (not
included).
2. Add the oil into the oil hole.
3. Install and tighten the oil plug (10).
The oil capacity is approximately 5 oz. (150ml).
8
WARNING
WARNING
CAUTION
IMPORTANT