Worx WX15RT Traduction Des Instructions Initiales page 9

ADDITIONAL SAFETY RULES
FOR YOUR ROUTER
1. Hold tool by insulated gripping
surfaces when performing an
operation where the cutting tool may
contact hidden wiring. Contact with a
"live" wire will make exposed metal parts
of the tool "live" and shock the operator.
2. Use clamps or another practical
way to secure and the workpiece
to a stable platform. Holding the work
by hand or against your body leaves it
unstable and may lead to loss of control.
3. Always wear a dust mask.
4. Wear protective glasses and hearing
protection.
5. For long hair, wear hair protection. Work
only with closely fitting clothes.
6. If the mains cable is damaged or cut
through while working, do not touch
the cable. Never use the machine with a
damaged cable.
7. Do not operate the machine in rain or high
moisture conditions.
8. Always direct the cable to the rear away
from the machine.
9. Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
10. When working with the machine, always
hold it firmly with both hands.
11. Secure the workpiece. A workpiece
clamped with clamping devices or in a vice
is held more secure than by hand.
12. Before putting into operation, check the
routing tool for firm seating.
13. Never route over metal objects such as
nails or screws.
14. Keep hands away from rotating router bits.
15. After finishing work, guide the machine
back into the upper starting position by
actuating the clamping lever and switch the
machine off.
16. Always switch the machine off and wait
until it has come to a standstill before
placing it down.
17 . Protect tools from impact and shock.
Router
18. Never allow children to use the machine.
19. Do not use blunt or damaged router
bits. Blunt or damaged router bits cause
increased friction, can become jammed
and lead to imbalance.
20. The allowable speed of the router
bit must be at least as high as the
maximum speed listed on the power
tool. Accessories that rotate faster than
permitted can be destroyed.
21. Never touch the bit during or
immediately after the use. After use the
bit is too hot to be touched by bare hands.
WARNING: Some dust particles
22.
created by power sanding,
sawing, grinding, drill and other
construction jobs contain chemicals
known to cause cancer, birth defects
or other reproductive harm. Some
examples of these chemicals are:
Lead from lead-based paints.
Crystalline silica from bricks and cement
and other masonry products.
Arsenic and chromium from chemically
treated lumber.
Your risk from these exposures varies,
depending upon how often you do this type
of work. To reduce your exposure to these
chemicals:
Work in a well-ventilated area.
Work with approved safety equipment,
such as those dust masks that are specially
designed to filter microscopic particles.
9 9
EN