Worx WX15RT Traduction Des Instructions Initiales page 13

turning the clamping lever in anti-clockwise
direction, then switch on. Carry out the cutting
procedure with uniform feed. After finishing
the cutting process, slide the router upwards
again and switch off.
8. ROUTING WITH GUIDE BUSHING
The guide bushing (24) enables template and
pattern routing on work-pieces.
Place the guide bushing over the hole in
the center of the base plate, and align the
two through holes in the bottom of the base
plate with the countersunk holes in the guide
bushing. Fasten the guide bushing with the
nuts and screws provided.(See D)
9.ROUTING PROCESS (See E)
Choose a router bit with a smaller
diameter than the inner diameter
of the guide bushing.
Set the router with guide bushing against
the template. Release the clamping lever by
turning in clockwise direction and slowly
lower the router toward the work-piece until
the adjusted depth-of-cut is reached.
Guide router with projecting guide bushing
along the template, applying light sideward
pressure.
NOTE: The template must have a minimum
thickness of 8 mm, due to the projecting
height of the guide bushing.
10. SHAPING OR MOLDING
APPLICATIONS
For shaping or molding applications without
the use of a parallel guide, the router must be
equipped with a pilot or a ball bearing.
Lead the router sideward to the workpiece and
allow router bit to engage until the pilot or
the ball bearing of the router reach the corner
of the workpiece being machined. Guide the
router alongside the workpiece corner using
both hands, ensuring proper seating of the
base plate. Too much pressure can damage the
edge of the workpiece.
11. ROUTING WITH PARALLEL GUIDE
(Accessory – See F,G)
• Slide the parallel guide (21) with the guide
rods(27) into the base plate (10) and tighten at
Router
the required measure with the wing bolts (12).
• Guide the machine with uniform feed and
sideward pressure on the parallel guide (21)
along the edge of the workpiece.
12.ROUTING CIRCULAR ARC PROFILES
(See H, I)
• Reverse the parallel guide (facing surfaces
point upwards) and insert the guide rods into
the base plate. Fasten centring pin (22) to
parallel guide (through hole) with wing bolt (28).
• Puncture centring pin into marked centre
of the circular arc and guide router with
consistent feed across the workpiece surface.
13. ROUTING WITH THE ROLLER GUIDE
(See J,K)
Slide the parallel guide with the guide rods
into the base plate. Fasten the roller guide
with the guide roller mounted to the parallel
guide.
• Guide the machine along the workpiece edge
with light sideward pressure.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
13 13
EN