Preparing Treatment Areas; Patch Test; Using Ledsonic; Ledsonic+ Setup - QLARITE LEDSONIC+ Manuel D'utilisation

3. Charging indicator light (See Fig. 6)
• The "SELECT" key blinks orange whilst charging.
• The "SELECT" key illuminates in continuous orange when fully charged.
Notes: It is normal when the adaptor and the appliance feel warm during charging.
Warning: NEVER cover the appliance and adaptor during charging. When
charging/using, do not touch charging connector and any person simultaneously.
Once device is fully charged, please disconnect. Do not overcharge.
4. Remove the adaptor from the wall socket and pull the small plug out of the
appliance when fully charged.
5.2

Preparing treatment areas

• Start by cleaning your face with a non-oil based cleanser.
• Use the provided soft cloth to clean the surface of the attachment.
5.3

Patch test

• Familiarize yourself with the features of the LEDSONIC+ device.
• Turn on the LEDSONIC+ with the ultrasonic mode and test on a small patch of
skin and wait 24 hours.
• Light Test : Turn on the LEDSONIC+ with the Red LED attachment (and test
again with optional Blue LED attachment, this attachment does not include in
this package) and test on a small patch of skin with 3 minute treatment on the
same area. Wait 24 hours.
• The patch test is to ensure there are no adverse reactions. If irritation occurs
do not continue treatment and please consult a doctor or dermatologist.
Fig. 6

6. Using LEDSONIC+

6.1

LEDSONIC+ setup

6.1.1

How to change attachment heads?

Press the buttons on the left and right sides and place the selected attachment
onto the attachment connector base. (See Fig. 7)
6.1.2

Operating the system

(Please check with section 3.1
"LEDSONIC+ device description")
A) Ultrasonic Therapy Mode
• Step 1: Ensure Ultrasonic
attachment is correctly attached
on the connector base.
• Step 2: Long touch " " for power on.
• Step 3: Touch "SELECT" each time for selecting different frequency modes
(1MHz/ 5MHz) and energy levels (Normal/ Strong).(See Fig. 8 for the sequences
of the default setting when press "SELECT")
1 MHZ
1 MHZ
Normal Strong
Note: For details, please see section 6.2 "Treatment Tips"
• Step 4: To change the frequency mode or energy level, touch "SELECT" again.
The light indicator (See Fig. 6) will blink in different status in each selection :
Frequency Mode Level
Normal "1MHz" Blinking slowly
1 MHz
Strong "1MHz" Blinking quickly
Normal "5MHz" Blinking slowly
5 MHz
Strong "5MHz" Blinking quickly
Fig. 7
5 MHZ 5 MHZ
Normal Strong
Fig. 8
Operation time
Indicator Status
(auto power off)
15 mins
10 mins
15 mins
10 mins