Connection To The Climatic Chamber - Binder Pure Aqua Service Manuel De Montage

No liquid must pass by the cable connection into the inside of the measuring equipment.
Electrical hazard.
Danger of death.
Damage to the equipment.
Make sure that the installation site is dry.
4.3.

Connection to the climatic chamber

• Connect the hose for purified water (R3/4'' plastic connecting piece) to the R3/4 in male thread of the
measuring equipment. Insert one of the two gaskets delivered with the water hose. Conduct the hose
to the climatic chamber.
Figure 7: Delivered gaskets at the hose for purified water (state of delivery)
Figure 8: Measuring equipment connected to cartridge and mains unit with hose for purified water
• Connect the hose (R3/4'' plastic connecting piece) to the freshwater connection at the rear of the
climatic chamber. Insert one of the two gaskets delivered with the water hose. Observe the indications
on water connection given in the chamber's operating manual.
Mounting instructions BINDER Pure Aqua Service
WARNING
page 26/65