VELO FUGA Mode D'emploi page 5


The installation must be done by qualified technician according with the legal European Standards.

Before the installation check if the selected installation place fulfils the security distances which appears at the CEI

Before the hands dryer electrical connection it must be installed a bipolar switch with 3 mm contact opening gap.

The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction
Do not plug the hands dryer laid over sinks, bath tubes,
shower or whatever place where could be in contact with
water, in an exceptional way as well.
INSTALLATION:
fig-1. In order to open the cover, remove the two screws placed in the bottom part of the hands dryer. Separate the cover
pulling up and out simultaneously.
fig-2. Mark up the four fixing holes on the wall using the hands dryer rear base as a drill template. Make four 8 mm drills.
fig-3. Fix the rear base using the subjection screws.
fig-4. Make the electrical connection following the drawing indications. The connection must be made using an electrical hose
(H05VV-K 3x1.5 mm
first and then the living wires.
fig-5. The Electronic Board allows sensor sensibility regulation (Front view, right side potentiometer). Sensibility increases
turning the potentiometer clockwise. Please consider also the attach scheme to make these changes.
fig-6. Assembly the cover on the hands dryer base again. First of all fit the upper part and, finally, tight the screws removed
before. When cover was definitively adjusted, switch on the appliance using the bipolar switch described in Attention
instructions.
The hand dryer operation is produced by physical proximity. When you place the hands below the hands dryer it will
operate continuously, when you remove the hands from this position it will stop automatically.
HAND DRYER MAINTENANCE
The sole maintenance operations that you must make over the hand dryer are to extract the dust from electronics and
ventilator, and the external cover cleaning. In order to make the last one, take care and do not use aggressive products which could
damage the cover. In any case, to use a wet rag without any other product is recommended.
To extract the dust from hand dryer internal components, follow the below instructions:
1. Unplug the hand dryer from electricity.
2. Remove the front cover as it is explained in fig-1.
3. Remove the dust from all components using a soft brush.
4. It is very important to clean perfectly the blower, the air inlet and the air outlet.
5. Be sure that sensor is perfectly clean.
INSTALLATION MANUAL:

Before any electrical manipulation, cut the electrical current.

The hands dryer could not be installed on a normally inflammable surface.

Children being supervised not to play with the appliance
ATENTION!
2
) through the gland provided in the accessories bag. When installing, connect the ground wire
ATENTION!
standards. (fig-0)
If the plug cord is damaged, it must be substituted by the
manufacturer, by an authorized technical assistance service
or by qualified people to avoid danger situations. Plug cord
USER'S MANUAL:
ATENTION!
reference is 60/0341