Quick QCC-LCS TP TS 4.3'' Mode D'installation Et D'emploi page 20

CONFIGURATION
EN
At this point, the wizard requires the selection of the lighting device category and the type of light source (single-colour,
RGBW or Tunable White) for the identified area.
MAIN SALOON
Downlights zone A
MAIN SALOON
RGBW
White light
always on:
select "single-colour"
light icon
Once the lighting characteristics of the detected area have been defined, you will be asked if you wish to add a new zone
and then repeat the configuration steps (from 1.2 to 2.2), or complete the procedure.
What do you want to do?
Add a new zone
End Wizard
Complete the procedure.
2.1 Device category selection
Select the icon of the lighting category.
Options:
Downlight A, Downlight B, Linear A, Linear B,
Applique, Table light, Courtesy, Underwater
The selected box will have a green frame.
The selected option (e.g., zone A Downlights) appears below.
OK
confirm by pressing "OK".
2.2 Selection of light source type
Select the light source type (e.g., RGBW).
If the type of light source is not known, visually check how the
F
lighting equipment of the identified area function, as described in
the box below.
In this case, the selection is binding because the area
management page changes according to the type of light source.
OK
Pay attention to the selection.
Red and green
alternating light:
select "RGBW"
light icon
Add a new zone.
Repeat configuration
20
Warm and cold white
alternating light:
select "Tunable White"
light icon
MAIN SALOON
Trova zona
Find zone Find zone
It is possible to set up to 12 zones per
room.
QCC-LCS TS - REV001A
Find zone
Find zone
OK
QUICK SPA