Lighting Instructions - GREADEN GR-3B31NA Mode D'emploi

LIGHTING INSTRUCTIONS :

1. Read instruction before lighting.
2. Open the lid and make sure all the knobs are on the OFF position.
3. Connect the regulator to the gas bottle. Turn the gas supply "ON" at the cylinder. Check with the
use of soapy water for any gas leakage between the bottle and the regulator.
4. Push down and turn the knob anticlockwise to HIGH position (a clicking sound is heard). The
burner can now be lit. If the burner does not light, repeat this process.
5. Adjust the heat by turning the knob to the High/Low position.
6. To light up other burners, repeat the same process for the adjacent burner and continue in
sequence until all the burners are lit.
7. To turner the barbecue OFF turn the cylinder valve or regulator switch to the "OFF" position and
then turn all of the control knobs on the appliance clockwise to the "OFF" position.

If any burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve off. Wait
five minutes before attempting to relight with ignition sequence.
Before cooking for the first time, operate the barbecue for about 15 minutes with the lid closed and the
gas turned on high. This will "heat clean" the internal parts and dissipate odour from the painted finish.
(the color of cooking area may change slightly. This is normal and it is nature of material).
Clean your barbecue after each USE.
parts of the product and may start a fire. Clean in warm soapy water.
DO NOT
use abrasive or flammable cleaners, as it will damage the
54