Closing; Mantle; Installation Instructions; Regulations - Truma LZS Mode D'emploi / Instructions De Montage

Hold knob in position for about 10 seconds after lighting
(activates safety pilot).
Do not touch the mantle (3)!
Lamps are supplied with opened air regulation (2). In case
they puff, choke the supply of fresh air by turning the air
regulation (2) until the flame burns softly and a maximum of
brightness is reached.

Closing

Push the grey button (1) all the way up. Close the quickac ting
valve in the gas supply line and turn off the gas cylinder.

Mantle

Only the Original Truma screw-on-mantle guarantees a
maximum of brightness and durability!
Please handle the mantle with care and never touch the ash
frame! For packing the mantle has a protection cover, which
burns off smoking slightly.
Screw on a new mantle and burn off protection
cover without gas. Always replace a defective mantle
to avoid damaging the globe. Keep a spare mantle ready!
Remove remaining ash!

Installation instructions

The installation or repair is only to be carried out by an
expert! Read the installation instructions carefully prior to
starting work and observe the instructions.
When installing in closed rooms sufficient ventilation must be
ensured.
Declaration of conformity
The Truma ceiling lamp has been design tested by the DVGW
and complies with the EC gas directive (90/396/EEC) and
other applicable EC directives. The following EC product ident.
no. is available for EU countries: CE-0085AQ1054.

Regulations

The LZS lamp is designed for an operating pressure of
30 to 50 mbar.
In Germany gas appliances, cylinder mounting, duct routing
as well as approval and leak test must comply with the DVGW
form G 607 for liquid gas systems in vehicles.
Use on boats is not permitted.
If the appliance is to be marketed or installed in a coun-
try other than Germany, the appropriate technical and
administrative regulations of the country in which the vehicle
is registered for the first time must be observed.
7