Installation And Connection - Renson Cube TouchDisplay Manuel D'instruction Pour L'utilisateur

5 • Installation and connection
This appliance was built for indoor use in a domestic environment.
Only use the TouchDisplay for its designated purpose. The use of the unit for applications other
than those mentioned in this manual and/or making modifications to the TouchDisplay is not
allowed. RENSON
use of the TouchDisplay.
Put the TouchDisplay in an interference-free environment in order to facilitate the transmitting/
receiving of the RF-signal.
The TouchDisplay can only be used in combination with a RENSON
It is advised to perform the linking procedure* before installing and connecting the
TouchDisplay.
Preferably put the display on an inner wall at eye level (cfr. installation of a thermostat)
• Living room with open kitchen:
Put the TouchDisplay in the living room in the proximity of the kitchen
• Closed kitchen:
Put the TouchDisplay in the kitchen
Do not expose the unit to direct sunlight in order to ensure a correct reading of the display.
* see section 6: 'linking the Touchdisplay with the ventilator'
EN
110
NV cannot be held accountable for any damages caused by erroneous
®
Cube ventilator unit.
®