Rs485 Connections - FujiFilm SX800 Manuel De Base

Installation and Connection

RS485 Connections

When the camera is connected to a monitor via HD-SDI or the like, you can view the live feed, control the camera, and adjust
camera settings using an Pelco D/P-compatible control unit connected to the camera via RS485.
SX800
1
Connect the supplied plug to the power cable and plug the cable into the
camera power connector.
4
Use only DC 12 V power.
CAUTION
b
Customers must supply their own power cable.
TIP
2
Connect an RS485 signal cable to the six-pin connector RS485 contacts
(page 13).
3
Select RS485 mode by setting DIP switch A to "ON" and DIP switches B
through D to "OFF".
4
Turn the camera on.
RS485 (Pelco D/P) connection
EN-10
Pelco D/P-compatible
remote control
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8