Safety Precautions; For Your Safety; Warnings; Cautions - FujiFilm SX800 Manuel De Base

Masquer les pouces Voir aussi pour SX800:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

For Your Safety

This section lists important precautions that must be followed to ensure safe and correct use of the product. Read them before
using the product and observe them during use.
4
4
The
WARNING and
4
Failure to observe warnings could result in death or serious injury.

WARNINGS

4
Failure to observe cautions could result in injury or property damage.

CAUTIONS

4
4
WARNINGS
WARNINGS
• Take all steps necessary to prevent water entering the product. Failure to observe this precaution could result in fi re or electric
shock. Should water fi nd its way in, disconnect the power source immediately.
• Be sure the product is installed securely. Serious accidents could result should the product fall from a height.
• When working in high places, work with a partner or partners, use a safety line, and take all other precautions necessary to
ensure safety. Slipping, falling, or loss of balance could result in serious accidents.
• When installing the camera in high places, ensure that people below keep their distance. Falling objects could cause serious
accidents.
• Ensure that the surface on which the camera is installed is level. Failure to observe this precaution could cause the camera to
fall, potentially causing serious accidents.
4
4
CAUTIONS
CAUTIONS
• Keep the product out of direct sunlight.
• Do not turn the product on without fi rst confi rming that the power supply is connected correctly.
• The product could cause injury if dropped during transport. Take all precautions necessary to ensure that the product is not
dropped.
• Ensure that the voltage of the power supply matches the product's rated voltage. Incorrect voltages could damage the product
or result in fi re or electric shock.
• When connecting or disconnecting the power cable, hold the plug and not the cable. Damage to the cable could result in fi re
or electric shock.
• Should you detect any abnormalities such as smoke, unusual noises or smells, or the presence of foreign matter inside the
product, disconnect the power supply immediately and contact the original retailer.
• Do not disassemble or modify. Failure to observe this precaution could result in electric shock or product malfunction. Mal-
functions or damage resulting from customers disassembling or modifying the product are not covered under warranty.
• Do not aim the camera at the sun. Direct sunlight focused through the lens could damage the product's internal parts.
• Install the camera base down. Installing the camera in other orientations could lead to warping that may impair product per-
formance.

General Precautions

General Precautions
• Use the product only as described in this manual.
• The camera and its accessories are precision devices. Under no circumstances should they be subjected to excessive force.
• Install the camera in a housing or other location where it will not be exposed to rain, wind, dust, or direct sunlight.
• Bringing the camera abruptly from a cold location to a warm and humid environment could cause the lens to fog. Take mea-
sures to allow the camera to adapt to the new environment before subjecting it to changes in temperature and humidity.
• Replace the cap if the camera will not be used for an extended period.
• The camera lens has a special anti-refl ective coating. As a result, the back of the lens may appear spotted, but this has no eff ect
on performance.

Safety Precautions

CAUTION indications in this document indicate the following:
EN-1

Publicité

Table des Matières
loading

Table des Matières