Pots And Pans; Function Check; Switch Off - Lotus cooker PCID-64ETX Instructions Pour L'installation Et L'emploi

Induction generators only work properly with saucepans with an iron base. (Recommended brand Spring,
Demeyere, Noser)
PCI The pans must have a diameter of between 120 mm and 260 mm. It is best for the bans to have a flat base.
PCIW For Wok machines, the pans must have a concavity that adapts to the glass standard 311 Ø mm. (see
Photo)
The generator does not accept unsuitable pans.
Any other product no mentioned in this paragraph should be considered automatically excluded and unsuitable for use
with induction generators.
After everything is connected perform the function check.
•
Remove pot from the cooking zone.
•
Adjust the cooking level to zero.
•
Switch on the mains supply.
•
The green and the red lamp must not light or blink.
•
The display must only show the cooking level 0.
•
Increase the cooking level to any number.
•
Green lamp must blink every second regularly (pot detecting mode).
•
On the display pot detection symbol
•
No fault must occur.
•
Red lamp must not light / No error code on the display.
•
Place on cooking zone a water filled induction pot which has a minimum of 12 cm Ø.
•
Green lamp or display must continuously be on.
•
Adjust to maximum power.
•
After a few minutes the fan must switch on.
Do not heat empty pans without supervision.
Always place pans in the centre of an inductor zone. Pans should not
be heated up to more than 300° C.
If an error occurs, refer to next section on troubleshooting.
· Turn the knob/potentiometer in a clockwise or anticlockwise direction until it is in the rest position [ OFF ]
· Certain parts of the generator are still powered even when the cooker is switched off. Therefore, if carrying out
maintenance work, disconnect the appliance from the power supply first.
· Make sure that no liquid penetrates the induction generator, either during normal use or during cleaning and
maintenance of the component .
GB IE

POTS AND PANS.

FUNCTION CHECK

must blink (pot detecting mode).

SWITCH OFF

50