Connections - Yamaha T-D500 Mode D'emploi

Note
If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized Yamaha dealer or service center
about outdoor antennas.
Indoor FM
antenna
(supplied)
RCA stereo
cable
(supplied)
Analog audio
Ground
For maximum safety and minimum interference, connect the
antenna GND terminal to a good earth ground.
A good earth ground is a metal stake driven into moist earth.
■ Assembling the supplied AM loop
antenna
4
En

CONNECTIONS

AM loop antenna (supplied)
• The AM loop antenna should always be connected, even if
an outdoor AM antenna is connected to this unit.
• The AM loop antenna should be placed away from this
unit.
Optical
cable
input
Amplifier
Outdoor AM antenna
Use a 5 to 10 m of vinyl
covered wire extended
outdoors from a window.
Coaxial digital
audio cable
Note
The DIGITAL RADIO OUTPUT jacks (OPTICAL
and COAXIAL) output the digital audio signals
(PCM signals) when this unit is in the DAB tuning
Digital audio
mode. DAB audio signals are also output the
input
ANALOG OUTPUT jack of this unit. FM or AM
audio signals are not output at the DIGITAL
RADIO OUTPUT jacks.
■ Connecting the wire of the AM loop
antenna
black
Indoor DAB antenna (supplied)
Stretch out the antenna and place it to
find the best reception position then fix it.
y
It is recommended that you use the
Tune Aid function in order to
maximize DAB reception capability
(see page 9).
To the AC wall outlet
CAUTION
Do not connect power
cable until all cable
connection are complete.
white