Grounding Instructions; Extension Cords - SpeedClean FLOWJET-60 Instructions D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Call SpeedClean® to check compatibility before using any chemical in the unit —
DO NOT use any cleaner that contains sodium hydroxide or potassium hydroxide.
DO NOT mix chemicals.
Use only approved accessories and replacement parts.
Always turn machine off and relieve pressure in the hose after use.
DO NOT run the unit dry – it may damage the pump. Always ensure adequate water supply.
DO NOT spray the unit with water or chemicals. Never expose the unit to rain. Store
unit indoors.
DO NOT allow the unit to freeze or leave in freezing temperatures.
The unit is equipped with an automatic by-pass valve that recirculates water inside the pump
when the spray gun trigger is released. Although the unit has a thermal discharge valve for
protection, avoid leaving the unit running in by-pass mode for more than five (5) minutes.
DO NOT ADJUST BYPASS PRESSURE: The bypass pressure is factory set — adjustments may
damage unit!
FlowJet-60
Make certain that the power source conforms to the requirements of the equipment.
Keep all connections dry and off the ground. Do not handle the unit or electrical plug with
wet hands.
Unplug the power cord when servicing the unit or leaving the machine unattended.
Do not pull on the power cord or pull the cord around sharp corners. Keep the cord away
from hot surfaces. When unplugging the power cord, grasp the plug — not the cord.
WARNING: The cords, wires, and/or cables supplied with this product may contain
chemicals, including lead or lead compounds, known to the State of California to cause
cancer and birth defects or other reproductive harm. Always wash hands thoroughly after
handling the unit.
GROUNDING INSTRUCTIONS: For proper protection this product must be grounded. Always
plug the power cord into a properly grounded receptacle. Never remove the grounding
prong from the power cord plug or use an adapter that eliminates ground.
GROUND FAULT CIRCUIT INTERRUPTER: This unit is provided with a Ground Fault Circuit
Interrupter built into the power cord plug to prevent electrocution. DO NOT RUN THE UNIT
WITHOUT THIS DEVICE!! If replacement of the plug or cord becomes necessary, use only
identical replacement parts that include GFCI protection.
EXTENSION CORDS: Use only extension cords that are intended for outdoor use. These
extension cords are identified by a marking "Acceptable for use with outdoor appliances;
store indoors while not in use." Use only extension cords having an electrical rating not less
than the rating of the product. Do not use damaged extension cords. Examine extension
cord before using and replace if damaged. Do not abuse extension cord and do not
yank on any cord to disconnect. Keep cord away from heat and sharp edges. Always
disconnect the extension cord from the receptacle before disconnecting the product
from the extension cord. SpeedClean recommends 12 BWG min, 50 ft max length.
SAVE THESE INSTRUCTIONS!!
© 2018 All Rights Reserved.
Electrical Precautions
3

Publicité

Table des Matières
loading

Table des Matières