Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
To ensure proper drawer operation, be sure
your support boards are flat & level.
A
B
C
E
D
*Dependent on application. Top of
support boards must be 1/2" above the
bottom edge of the cutout.
4. When installing your support boards, be sure they are level.
5. Ensure that the bottom of the center divider rests on top of the support boards as shown (Fig. 4A).
1-1/2" Bottom of center divider to
2-5/8"
21-1/2" support
boards must
t in this area.
Fig. 4A
FRONT VIEW (TYPICAL)
Support Board (typical)
Sticker location of
Model, Serial, Code Number
SUPPORT BOARD DIMENSIONS
*
island cutout
Model A
48"
36"
30"
24"
END VIEW (TYPICAL)
For proper
support & drawer
operation, insure
that support
boards are level
front to back &
side to side.
Fig. 6A
7
B
A
B
C
2 X 20" 1-1/2"* 3-1/2" min. 14 12
20"
1-1/2"* 3-1/2" min. 14
2 X 20" 1-1/2"* 3-1/2" min. 14 12
20"
1-1/2"* 3-1/2" min. 14
Fig. 5A
Support Boards
(typical)
D
E
–
–
Publicité
Chapitres
Table des Matières
