Mode Adjustment - Toto TLK03001G Manuel D'installation Et Guide D'utilisation

Setting the Dispensing Volume of Liquid Soap
The dispensing volume of liquid soap has been adjusted to 0.04 o.z before shipping from the factory.
This volume can be changed to 0.06 o.z by pulling out the connector.
1. Remove the controller cover.
2. Remove the connector cord from the hook.
3. Pull out the connector.
4. Hang the connector on the hook.
(To prevent loss)
5. Mount the controller cover.
Caution
Tighten the screws securely.
If water is splashed over the tank, the water can
penetrate into the controller and cause damage.
Note
If the connector is connected again, the liquid
soap dispense volume is reset to 0.04 o.z.

MODE ADJUSTMENT

Screw
19
Screw
Controller cover
Screwdriver
Connector
Connector
Controller cover
Screwdriver
Hook
Pay attention not to
pinch the cord.