Refilling The Tank - Toto TLK03001G Manuel D'installation Et Guide D'utilisation

Please refill the tank with liquid soap when the internal sensor lamp (red) starts blinking.
1. Remove the cap on the tank.
2. Slowly pour the liquid soap into the holding
tank.
Please keep an eye on the level as you
pour the liquid soap in slowly so that it
doesn't become foamy. Please pour the
liquid soap through the built-in filter.
3. Firmly close the cap on the tank.
Please make sure that the cap is securely
in place after filling the tank.
Filling the Sub-Tank (Only if a sub-tank has been installed.)
When a sub-tank has been installed, please fill
the liquid soap from the opening in the sub-tank.
Note
Pour soap slowly to avoid bubbles in the tank.
 If the soap is very slow to drain into the
tank where excessive bubbling occurs,
please clean the filter and cap area.

REFILLING THE TANK

18
Sensor
Filter
Open
Close