ROTOR Gastronom GK900 Mode D'emploi Pour La Réparation page 8

REP-GK900-1127-1-DE-EN-FR
2.0 Repair Intstructions
2.1 Repalce the drive wheel
Art.Nr. Bezeichnung
8
1120.930 GT Spezial Gabelschlüssel SW8
120.931 GT Demontage Schlüssel
Reparaturanleitung / Repair instructions /
Rotor Gastronom GK900 / GK600
Removing the drive wheel
Fitting the drive wheel
If the only drive wheel has been detached,
this is screwed on and tightened by running
the motor at the very lowest speed and hold-
ing the hand against the drive wheel until the
wheel is tightened.
Beware of rotating parts!
If the drive wheel has to be detached, a blunt
object can be placed against a driver rib of
the drive wheel and the drive wheel can then
be loosened with a sharp hammer blow (right
-handed thread, loosen in the anti-clockwise
direction).
Designation
GT special spanner AF8
GT dismounting spanner
Mode d'emploi pour la réparation
- Remove base plate
- Place the special fork wrench
(1120.930) between the commutator
and frame over the milled faces of the
motor shaft.
- Place the special wrench (1120.931)
in the drive wheel and turn to the left.
- Component is fitted in the reverse
sequence to removal.
Désignation
GT clé à fourche spéciale
GT clé de démontage
St/
Qte
1
1