Storage; Warranty - MiniDive Pro Mode D'emploi

• In case of shock, the equipment can be damaged without visual harms, in case of doubt, make your equipment
inspected by a specialist
• It is totally forbidden to change the layout or to modify the different pieces of the MiniDive Pro (Pro+, Carbon, Carbon+,
Carbon Max)
• Never integrate elements from the MiniDive Pro (Pro +, Carbon, Carbon+, Carbon Max) on an other (diving) equipment
or vice versa
• Never introduce water in the equipment
9.

Storage

• After the drying, store the products in a box or a clean and closed bag
• Store the products in a dry place, protected from the light, between +5°C and 35°C (41°F to 35 °F)
• Let the valve closed during storage, the top compartment should not be under pressure
• Do not store the products near gasolines, oils or other chemical products
• Do not store the products in a dusty place or where there is sand
• The flexible should be free from all constraints, tank should be in a vertical position, valve to the top
During storage, remove the first stage regulator from valve
•
10. Maintenance and upkeep
• The proper functioning and the proper preservation of your equipment do not necessarily depend on its frequency of
use. Even when it is not used, a bad storage can significantly damage the device
• Make your MiniDive Pro (Pro+, Carbon, Carbon+, Carbon Max) regularly inspected by a specialist, an annual
inspection is recommended
• The French law impose inspection or obligatory re-test for the MiniDive Carbon+ or Carbon Max every 2 years. It
is not mandatory but recommended for the MiniDive Pro, Pro+ or Carbon (inquire by country)
• The French law do not impose inspection or obligatory re-test for the pressure regulator but it is advisable (inquire by
country)
• Unscrew the pump filter (black sheath) and heat it up at 50°C (122°F) during 20 minutes every 10 full filling of the tank
(every 5 full refill in wet locations)
• It is recommended to replace the M4S pump filter every 30 refills
• It is possible that after a certain number of refill, the movement of the pump becomes harder, apply silicon grease in
small quantities on the metallic tube of the pump
• Prefer the replacement of a defective piece by an original one
• If there is a leak in the 1
• Do not try to fix your equipment by yourself else-way than by the instructions given in this manual
• Do not forget that your security and the proper functioning of your equipment depend on its maintenance
• For the upkeep of your regulators and your tank, consult a diving center
• If you need help about use or repair of the product, check our tutorials on youtube.com/minidive
• A FAQ is also available for all products on minidive.com

11. Warranty

• The equipment is guaranteed for one year starting from the date of purchase of the products
• The guarantee is only valid for the first owner of the equipment
• In case of claim for guarantee, you will have to have a proof or purchase delivered by your dealer
• This guarantee is only valid for « defective » pieces due to a manufacturing fault
• A non-followed maintenance can engender a guarantee cancellation
• The guarantee does not cover the damages caused by a faulty use or by carelessness like it is said in this present
document
• The guarantee does not take in charge the « normal » usury of the products. The guarantee does not include the
recommended periodic inspections. The guarantee is invalidated if the equipment has been disassembled in a different
way from this guide
• In a case of modification of the product by a qualified person, he or she undertakes the responsibility of the repairs/
changements done on the product
• The guarantee is available for the repair or the replacement of a piece by MiniDive, the freight charges and the packing
costs are on the buyer
• The exchanged pieces are MiniDive's goods. These new replaced pieces cannot extend the guarantee of the product
in any case
stage, tighten the MP output with your hand and the DIN connection with a Allen key
st
and protect the output with the cap included
9