Setup Menu (Rgb Mode: Rgb1 (Dvi-Pc), Rgb2 (Rgb)) - Yamaha PDM-4220 Manuel Utilisateur

OPERATING INSTRUCTIONS (continued)

SETUP MENU (RGB mode: RGB1 (DVI-PC), RGB2 (RGB))

Picture
Audio
Timer
Function
MENU
Setup
Language
Select
OK Set
Selected characters
Auto Adjust*
Horizontal Position
Vertical Position
Horizontal Clock
Clock Phase
Reset
Input Level
Frequency Display
WVGA Type
WXGA Mode
30
– Pressing the OK button here,
Automatic regulation is started.
Moves the horizontal position
Moves the horizontal position
to left. to right.
Moves down the vertical
Moves up the vertical position.
position.
Reduces the dot clock frequency
Increases the dot clock frequency
(shrinks the right side).
(expands the right side).
Advances the dot clock
Slows the dot clock phase
(shifts slightly to left). phase (shifts slightly to right).
(off the function) (waiting to reset)
0.7V
Off
Off
Off 1280x768
Setup
Auto Adjust Adjust
Horizontal Position 0
Vertical Position + 31
Horizontal Clock – 20
Clock Phase 10
Reset Reset
Select OK Set Return
Setup
Auto Adjust Adjust
Horizontal Position 0
Vertical Position + 31
Horizontal Clock – 20
Clock Phase 10
Reset Reset
OK
Select Set Return
Setup
Input Level 0.7V
Frequency Display Off
WVGA Type Off
WXGA Mode Off
Vertical Filter On
Frequency Mode Movie
RGB1 DVI-PC
RGB2 RGB
Select Set Return
Adjust
Horizontal Position, Vertical Position, Horizontal Clock and Clock
Phase are adjusted automatically.
Adjust the left-side display position.
Screen display changes to Magenta colour if beyond the available
range. (This function is only for RGB2. It's not available (greyed
out) for RGB1 (DVI-PC).)
Adjust the vertical display position.
Screen display changes to Magenta colour if beyond the available
range. (This function is only for RGB2. It's not available (greyed
out) for RGB1 (DVI-PC).)
Adjust for maximum character clarity.
(This function is only for RGB2. It's not available (greyed out) for
RGB1 (DVI-PC).)
Adjust for clear character visibility.
(This function is only for RGB2. It's not available (greyed out) for
RGB1 (DVI-PC).)
The original factory settings for the items of this Menu page can
be restored by pressing the OK button.
Normally set to 0.7 V. If white is found to spread across the
1.0V
screen, set to 1.0 V. (This is effective only for RGB2.)
On
Set this to Off if the frequency information of the Input Signal
Screen Display is not required.
This is only available for W-VGA signal.
On
When it is set to On, the display area mode can be selected Full
or Real. (With RGB1 INPUT, the screen remains the same. RGB2
(ANALOG) INPUT only)
This is only available for W-XGA signal.
1366x768
(RGB2 (ANALOG) INPUT only)
Horizontal Position 0
Next / Prev Adjust Return
Clock Phase 10
Next / Prev Adjust Return
Setup hint