ThermoFlow OT-5 Instructions De Montage page 24

DE NL GB F TR PL D
Connection to the electricity supply
The device must be filled with water (see above). Only then may the
appliance be connected to the electricity supply (insert the plug in the
wall socket). Connection of the device to the power supply network
must take place in accordance with electric installation standards and
as specified by local laws and regulations. The device must be directly
connected to the power supply network (230V) via an electrical ca-
ble and plug.
Avoid danger from damaged power supply cables. In the event of
damage, the device must be replaced by the manufacturer or its cus-
tomer service department, or by an equivalently-qualified person.
Ensure that the addition of this boiler will not overload the fuse pro-
tection in your mains.
Internal modifications to the product may cause problems if this work
is not carried out by authorized and qualified technical staff. The war-
ranty only applies if the product has not been modified in any way, i.e.
subject to it being in unchanged condition.
In order to avoid creating an unsafe situation by inappropriate reset-
ting of the maximum temperature safety device, this unit may not be
powered via an external switching device (a time switch for example)
or connected to a circuit, which is regularly switched on and off by
the power supply company.
24