Basic Operation Of The Setup Menu; Speaker Setup - Yamaha RX-V765 Mode D'emploi

Basic operation of the SETUP menu

The SETUP menu screen appears on both video display
(OSD) and front panel display.
Video display (OSD)
Setup Menu

. ;Speaker Setup

;Sound Setup
;Function Setup
;DSP Parameter
;Memory Guard
[ ]/[ ]:Up/Down
[ENTER]:Enter
Front panel display
;Speaker Setup
In this section, procedures of setting menus displayed on
the video monitor are described.
1
Press jSETUP on the remote control.
The SETUP menu screen appears.
2
Select a menu using kCursor k / n, and
press kENTER.
Items of the selected menu are displayed. For
example, the following screen appears when you
select "Function Setup."
;Function Setup
. 1 HDMI
2 Display
3 Volume
4 Input Rename
5 Zone2
[ ]/[ ]:Up/Down
[ENTER]:Enter
y
• You can return to the previous screen by pressing kRETURN.
3
To display submenus, select a menu that you
want to set using kCursor k / n, and press
kENTER.
For example, the following screen appears when you
select "2 Display."
2 Display
. Dimmer;;;;;;;;;;;;0
FL Scroll;;Continue
OSD Shift;;;;;;;;;0
[ ]/[ ]:Up/Down
[ [
[ ]/[ ]:Adjust
4
Select an item using kCursor k / n, and
change the setting of the item using
kCursor l / h.
Some items in the Manual Setup menu of Speaker
Setup take up a full screen. To display other items in
the Manual Setup menu, press kCursor k / n.
Changing various settings of this unit (SETUP menu)
Example: A)Config
A)Config
Center SP
None >Small Large
y
• You can change other items by repeating step 4.
5
To finish setting, press jSETUP.
y
• If kCursor or other keys do not work after exiting the SETUP menu,
select the input source again using eInput selection keys.
Speaker Setup
You can set various items for speakers. Two kinds of
adjustments are available. One is "1 Auto Setup (YPAO)"
for automatic adjustment and another is "2 Manual Setup"
for manual adjustment.
y
• The default settings are marked with "*."
1 Auto Setup
Automatically adjusts output characteristics of speakers to
obtain optimum balance for the output sound based on
positions and performances of the speakers and acoustic
characteristics or the room, which are automatically
measured. For details on operations, see page 21.
2 Manual Setup
Adjusts output characteristics of speakers based on
manually set parameters.
After Auto Setup (YPAO) is performed, you can check
automatically adjusted parameters in the Manual Setup
menu. Fine adjust the parameters for your preference if
necessary.
■ A)Config
Sets speaker configurations, such as connection status of
speaker and a size of the connected speaker (sound
reproduction capacity), suitable for the listening
environment.
y
• The speaker configuration includes items for defining a speaker size:
Large or Small. Large and Small refer to speakers with woofer diameters
16 cm or larger and smaller than 16 cm, respectively.
Extra SP Assign
Zone2*/Presence/None
Choices:
Selects the application for EXTRA SP jacks.
Zone2
Assigns the EXTRA SP jacks for the speakers
in the second zone.
Presence Assigns the EXTRA SP jacks for the
Presence speaker.
None
Disables the EXTRA SP jacks.
Note
• When setting "Extra SP Assign" to "Zone2" or "Presence," the surround back
channel signals for main output is separately output from other channels.
45
En