Volfoni ActivHub RF50 Manuel D'utilisation page 6

2. IR > RF mode
1. Set the function selector to position 8.
2. Plug the USB connector to a powered socket or an
optional adapter.
3. Plug the micro-USB connector to the ActivHub
4. Check the blue LEDs light up to signal power on.
5. Turn the IR reception window towards the IR 3D source
like the 3DTV.
6. Check the blue LEDs starts blinking twice every 3 sec.
7. Make sure you keep the IR reception window turned
toward the 3D source.
Notes:
• The ActivHub RF50 blinking twice means a functional
TM
signals 3D sync input and its RF transmission.
• IR receiving mode requires a clear line-of-sight
between the ActivHub
TM
• If you experience interferences, or if you are using
many ActivHub RF50 in a single room or building, you
TM
may choose another channel between 3 and E.
3. DLP®-link™ > RF mode
1. Set the function selector to position 8.
2. Plug the USB connector to a powered socket or an
optional adapter.
3. Plug the micro-USB connector to the ActivHub
4. Check the blue LEDs light up to signal power on.
5. Turn the DLP-link reception window towards the
TM
screen or the projector.
6. Check the blue LEDs starts blinking twice every 3 sec.
7. Make sure you keep the DLP-link
turned toward the 3D image or source.
10
RF50 and the 3D source.
reception window
TM
Notes :
• The ActivHub
signals 3D sync input and its RF transmission.
• DLP-link
TM
RF50. between the ActivHub
TM
• Because DLP-link
it is very sensitive to ambient light. Optimal positions for
the ActivHub
-Close to the projector, turned toward the output lens
-Close to the projector, turned toward the screen
-Close to the screen edge, turned toward the projector
• If you experience interferences, or if you are using
many ActivHub
may choose another channel between 3 and E.
Note: Using Volfoni RF glasses require to update them
with a RF software.It can be downloaded from volfoni
website: www.volfoni.com.
4. RF (Volfoni) > VESA mode
1. Set the function selector to position F.
2. Plug the USB connector to a powered socket or an
optional adapter.
3. Plug the micro-USB connector to the ActivHub
4. Check the blue LEDs light up to signal power on.
5. Emit RF signal with another AcvtivHub
function selector to position 3-E.
RF50.
TM
6. Check the blue LEDs starts blinking three times every
three seconds.
7. At the output of the first ActivHub
VESA signal.
8. If you want you can put a Volfoni IR emitter at the
output of this ActuvHub
RF50 blinking twice means a functional
TM
receiving mode requires a clear line-of-sight
and the 3D image or source..
TM
signal is in the visible light spectrum,
TM
are:
TM
RF50 in a single room or building, you
TM
RF50.
TM
RF50.
TM
RF50 (with
TM
RF50 there is a
TM
11