Powering The Activhub; Selecting The Synchronization Source; Selecting The Emission Channel; Examples Of Setups - Volfoni ActivHub RF50 Manuel D'utilisation

Using seemingly compatible, yet non-Volfoni, glasses
with the ActivHub RF50 will most likely generate timing
TM
issues and degrade the 3D image quality, color fidelity,
sharpness and brightness. This may cause unwanted
eyestrain or fatigue.
These compatibility lists are indicatives. Due to possible
changes of protocol by manufacturers, Volfoni cannot
warranty compatibility with products previously cited
3. Using your ActivHub

3.1 Powering the ActivHub

The ActivHub RF50 gets its power either from the Jack
TM
or micro-USB ports. Do not plug both inputs to power-
providing devices at once, this may damage the
ActivHub or the host systems.
TM
The VESA port should be powered with either 5v or 12v.
If your VESA is not powered, then the ActivHub
can be powered via its USB port. In this case, make
sure to use an optional universal adapter rather than a
powered USB port on an electronic device.

3.2 Selecting the synchronization source

Synchronization source selection is automatic on the
ActivHub RF50.
TM
At power-on, synchronization sources like VESA,
DLP-Link and IR, are automatically checked by the
TM
ActivHub . As soon as any of these three signals is
TM
detected, the ActivHub
it until its next full power cycle. To switch to another
synchronization source, you need to power off the
ActivHub RF50.
TM
8
RF50
TM
RF50
TM
TM
will focus exclusively on
TM
The scan priority order is :
1.Wired 3D signal
2.DLP-link 3D signal
3.IR 3D signal

3.3 Selecting the emission channel

This option is only available with EDGE
ActivEyes
TM
The emission mode is selected by the function selector:
0 : Autotest mode
3 to E: RF channels
8 : Default RF channel
F: VESA channel
Please note that the position 1 and 2 are not to be used
in the ActivHub

3.4 Examples of setups

1.VESA-DIN3 > RF mode
RF50
1. Set the function selector to position 8.
2. Plug the Vesa or BNC connector to your 3D source
3. If using the BNC cable, plug its USB connector to a
power source.
4. Plug the Jack 3.5 connector to the ActivHub
5. Check the blue LEDs light up to signal power on.
6. Check the blue LEDs starts blinking twice every 3 sec.
Notes:
• The ActivHub
signals 3D sync input and its RF transmission.
• If you experience interferences, or if you are using
many ActivHub
may choose another channel between 3 and E.
Pro
RF50.
TM
RF50 blinking twice means a functional
TM
RF50 in a single room or building, you
TM
VR and
TM
RF50.
TM
9